Setting Your Company Logo

The Your Settings screen allows you set your company logo used for print outs.

Changing Your Logo

Click on the "Logo" button and an Open Image File dialogue will be displayed, allowing you to pick an image file of your company logo. Use a scanner to scan your company logo unless you already have it saved as an image on disk. The image file must be saved as a .JPG .BMP or .PCX file in order to be loaded into the SimplyPats program.

Scanning Your Company Logo

If you scan your company logo using a scanner, take care not to scan at a very high resolution. (high number of Dots Per Inch or DPI). You should aim to scan at between 100 and 300 dpi. If you scan at a high resolution your image will be very large and slow to load.

Cropping Your Company Logo

Make sure your company logo is cropped as close as possible. Avoid leaving a lot of white space around the image as this will cause your logo to print small despite what size you ask it to be printed in SimplyPats.

This image is cropped correctly.

This image has too much white space surrounding it.

Sizing The Company Logo On Reports

You can select whether the company logo is displayed and set the size that the logo is printed in the Print Setup screen under the File menu.

The maximum height you can print the logo at is 30mm.

If You Continue To Have Problems

If you continue having problems in sizing your logo or wish to have your logo scanned, or even a new company logo designed by our graphics department, call the support line.

Tel: 0845 4300 789 (Local Number) (National Rate) 10am - 4pm
Email: suport@simplypats.co.uk suport@simplypats.co.uk